EZN Plus Series
3
3.
Installation
This installation guide provides the basic instructions on installing an EZN Plus bullet IP camera. For
details, please refer to the
User’s Manual
in the software CD.
3.1
Mounting and Wiring
Follow the steps below for mounting and wiring the camera.
1.
Before screwing the camera to the wall, drill four holes on the wall according to the
hole-positions on the supplied Quick-Mounting Ring. If you wish to run the wires into the
wall, drill another hole in the middle of the circular area within the Quick-Mounting Ring.
2.
Push the four supplied anchors into the four holes on the wall.
3.
Place the Quick-Mounting Ring against the anchoring surface so that the holes line up.
Screw the Quick-Mounting Ring to the wall using the supplied Long Screws.
Quick-Mounting Ring
Long Screws
4.
Screw the camera body to the Quick-Mounting Ring using the supplied four Short Screws.
a.
If you want to wire the cables from the side of the camera base:
Camera Base
Quick-Mounting Ring
Cables
