Installation
Pull the plastic cover from the base plate. Mount the base plate onto the
wall where there is a good circulation of air. Install 4 AA alkaline batteries to the
battery holders or connect the external power source wiring to the screw
terminal. Press the push button to bind WT-22 radio to a host device. Once they
are bound, install the plastic cover back onto the base plate.
Note:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by on or more of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
-
Consult the dealer or an experienced radio/TV technician for help.
Caution:
This equipment is authorized for use under the United States Federal
Communication Commission Rules and Regulations, Code of Federal
Regulations Chapter 47 part 15 and must be installed in accordance with the
instructions provided in this document. Failure to install or operate this
equipment as instructed in this document could void the user’s authority to
operate the equipment. This equipment contains no user serviceable parts. Any
modification or repairs to the internal components or to the antenna configuration
of the equipment without the express written consent of Everex Communications,
Inc. could void the user’s authority to operate the equipment.
Note:
To comply with FCC RF exposure requirements in section 1.1307, a
minimum separation distance of 20cm (8 inches) is required between the
equipment and all persons.
Copyright © 2009 Everex Communications, Inc.
Everex Communications, Inc. reserves the right to change the content of this
user’s manual without notification
