EJ_3F012-3F013-3F014-INS-LAB-RevD20 • Traveler L3 Plus User Manual
16
hinge
plate
swingaway
release lever
remove elevating legrest
ELEVATING LEGREST—DETACHABLE, SWINGAWAY
WARNING: The footplates' lowest point should be no closer to the ground than 2
1
/
2
inches,
to permit proper clearance.
WARNING: Do not stand on the footplates; this could cause the wheelchair to tip.
REMOVE ELEVATING LEGREST
1. To release lock, pull swingaway release lever forward,
toward front of wheelchair. Legrest will swing outward.
2. To remove, lift legrest straight up off wheelchair hinge
pins.
ATTACH ELEVATING LEGREST
1. Set legrest on wheelchair (so that legrest hinge plates
engage wheelchair hinge pins).
2. Swing legrest inward.
3. Ensure legrest is locked in place and swingaway release
lever is locked in a rearward position, toward back of
wheelchair.
WARNING: Ensure legrests are locked in place
before occupying or operating wheelchair.
ADJUST LEGREST ELEVATION
CAUTION: It is possible to RAISE the elevating
legrest without moving the legrest release lever. As
a safety feature, however, in order to LOWER the
elevating legrest you must move the legrest release
lever. This is to prevent the legrest from accidentally
dropping while the user’s leg is elevated.
WARNING: Ensure elevating legrests are locked in place before occupying or operating
wheelchair.
Raise elevating legrest
Slowly rotate the legrest up to the desired position. Ensure elevating legrest is locked in position.
Lower elevating legrest
1. To allow the elevating legrest to lower without dropping suddenly, support its weight and move
the release lever forward.
2. Slowly lower elevating legrest to desired position.
3. Release lever. Ensure elevating legrest is locked in position before letting go of legrest.
