Everbilt 1005 588 347, Инструкция по использованию и уходу

Страница: 11 / 16

11 HOMEDEPOT.COM
Please contact 1-877-527-0313 for further assistance.
Installation - Joist-out (continued)
6
Preparing and installing the fan assembly
CX242DDWTEVB (DIRECT DRIVE)
□
Remove the fan blade and wire the motor first. See Step 8
on page 12.
□
Replace and secure the blade so it is about half in and half
out of the hub.
□
Tighten the fan blade set screw before operating and
make sure the hub of the fan blade assembly is facing up
towards the roof.
□
Push the fan assembly through the shutter opening
diagonally or through another attic access.
□
Place the frame on top of the facing or additional frame
and draw alignment marks around the base of the
assembly.
□
Secure the assembly to the facing using screws.
CX30BD-2SPDEVB (BELT DRIVE)
□
Remove the hardware and remount the motor on the top
side of the struts.
□
Position the fan belt on the pulleys and adjust it to fit
snugly with about 1/2-in. deflection. DO NOT OVERTIGHTEN
THE BELT!
□
Tighten the fan blade set screw and make sure the hub of
the fan blade assembly is facing up towards the roof.
□
Push the fan assembly through the shutter opening
diagonally or through another attic access.
□
Place the frame on top of the facing or additional frame
and draw alignment marks around the base of the
assembly.
□
Secure the assembly to the facing using screws.
7
Installing the shutter
CAUTION: Never operate the fan without the shutter
installed.
□
Draw alignment marks on the ceiling 7/8 in. from the edges
to indicate the outer edges of the shutter (B) frame.
□
Install the shutter (B) using the white-headed wood screws
(F) provided with your fan.
□
Caulk the seams for an airtight seal.
F
B