www.event-lighting.com.au
1
Technical Specifications
•
Power: 100 - 240V, 50 - 60Hz
•
Power Consumption: 1.75W
•
Power Connection: Seetronic® Outdoor Powerkon Input
•
Max Transaction Power: 23dBm
•
Receiver Sensitivity: -94dBm
•
Band: 2.402Ghz - 2.480Ghz, ISM, 79 channels
•
Spread Spectrum: FHSS, 1100 hops/s
•
Modulation: GFSK
•
Channel Groups: 6 in ELDMX mode
•
DMX Interface: Seetronic® 3 Pin Outdoor in / out DMX Interfaces
•
Housing Materials: Die-cast Aluminium Housing
•
IP Rating: IP65
Setup Mode
To enter Setup Mode, press and hold the button whilst powering up. Once the device powers up,
the unit will be in Setup Mode.
The light will be lit a specific colour to indicate the protocol being used for the transmission as
shown in Table 1 below.
Pressing the button will cycle through the colours and once you want to set the protocol pressing
the button for more than 1s will save the protocol.
The transmitters, receivers and transceivers will remember the protocol used even after a power
cycle with their built in memory chip.
Protocols
Table 1
Colour
Protocol
Red
ELDMX Transmit and receive
Green
W-DMX Receive
Blue
W-DMX G3 Transmit
Use Mode
Changing Channel Group
Pressing the Button will show you the current channel group being used and pressing it again will
cycle through the groups. The colour of the light will indicate the group as shown in Table 2.
