Installing the SensorSafe
TM
Chest Clip
25700973 7/15
Final Check:
• Pull on harness from front of seat to be sure it is properly secured to splitter plate and
does not come out.
• Make sure SensorSafe chest clip is threaded properly (Step 6).
• Make sure the harness is not routed over the base release lever (Step 8).
• Make sure harness straps are not twisted.
Re-attach harness
strap loops to splitter
plate at rear of seat.
Harness straps must
NEVER
be routed over
the base release lever.
Make sure straps are
not twisted.
IMPORTANT:
Make sure
both harness straps are
installed
completely
on the splitter plate, as
shown.
Push straps through proper slots in
seat pad and corresponding slots
in seat back. (See child restraint
instruction manual to identify correct
set of slots for your child).
ARMPIT LEVEL
Remove straps from chest clip.
DISCARD the chest clip.
ARMPIT LEV
EL
Attach SensorSafe chest clip by sliding
the harness straps in bottom slots,
and then in top slots. SensorSafe logo
should be facing forward. Make sure
straps are not twisted.
Pull harness straps through seat back
and seat pad to front of seat.
Before starting chest clip change,
secure harness by snapping chest clip
together and snapping tongues into
crotch buckle.
Loosen harness straps by pushing
down metal harness release button at
front of seat while pulling upward on
harness straps.
General Information about SensorSafe
TM
Locate the 16PIN OBDII port
A
in your vehicle. Refer
to your vehicle owner’s manual for location. Plug in
the SensorSafe Receiver.
Your SensorSafe Receiver will sound one prolonged
tone when it first communicates with the vehicle
network. In some vehicles this occurs immediately after
installing the SensorSafe Receiver, in other vehicles
the tone will not be heard until the vehicle has been
started.
This initialization signal only occurs one time after
installation.
Remove harness strap loops from
splitter plate on back of seat.
Your SensorSafe Chest Clip is designed to “go
to sleep” if clipped for more than 12 hours.
The chest clip will “wake up” or reset by
simply opening and closing.
TO PRESERVE BATTERY LIFE, ALWAYS STORE
THE SENSORSAFE CHEST CLIP IN THE
UN-CLIPPED POSITION.
Install the SensorSafe Receiver.
Power up the vehicle.
Cycle the SensorSafe Chest Clip.
Using the SensorSafe
TM
System
Secure your child into the child restraint as you would normally. The SensorSafe
Receiver Plug monitors both the Chest Clip Transmitter and the vehicle. When you
arrive at your destination and turn your vehicle off, the SensorSafe system sounds a
series of gentle tones reminding you that your baby is in the vehicle.
Install it once and SensorSafe is always ready to alert you.
Battery Usage
• To preserve battery life, always store the SensorSafe Chest Clip in the un-clipped
position.
• The Chest Clip includes 1-button cell lithium battery that cannot be recharged or
replaced. Dispose of Chest Clip properly.
• Battery life under normal usage is estimated at approximately 6 years. If your
Chest Clip battery is getting low, the SensorSafe Receiver will make a “low
battery” alarm when the Chest Clip is closed. This “low battery” alarm will sound
different from the beeps you typically hear when activating your SensorSafe
system. Please contact Evenflo’s ParentLink at: 1-800-233-5921 (U.S.),
1-937-773-3971 (Canada), or 01-800-706-12-00 (Mexico) to order a
replacement SensorSafe Chest Clip.
1
2
3
ARMPIT
LEVE
L
A
Chest Clip Transmitter
Receiver Plug
Important Usage Information
• These instructions and the instructions in your vehicle owner’s manual must be
followed carefully. If there is a conflict between the two, the vehicle owner’s
manual regarding child restraint installation must be followed.
• SensorSafe is compatible
ONLY
with Evenflo Embrace Infant Car Seats that have
a maximum weight rating of greater than 13.6 kg (30 lbs).
• The SensorSafe system consists of two components:
1. The Chest Clip Transmitter and 2. The Receiver Plug. The system will not work
unless both of these components are present in the vehicle with the Receiver
installed in the vehicle’s OBDII port.
• The SensorSafe Chest Clip is designed to go into a sleep mode after being
clipped for 12 hours. Although 12-hour vehicle trips without stops are
uncommon and not recommended, the Chest Clip must be opened and closed
after 12 hours to reactivate the SensorSafe system.
• The Receiver Plug works
ONLY
with 2008 or newer gas/diesel equipped vehicles
purchased in the U.S. or Canada. If you would like to use the SensorSafe Chest
Clip with a Hybrid or Stop/Start vehicle, please contact Evenflo’s ParentLink
at: 1-800-233-5921 (U.S.), 1-937-773-3971 (Canada), or 01-800-706-12-00
(Mexico) to order a compatible Receiver Plug.
Note:
SensorSafe Receiver will also alarm within 30 seconds if your child un-clips the Chest Clip after
the vehicle has been driven for 30 seconds at 5 miles per hour or more, but only if the vehicle is on.
FCC Certified - Model: SOS, FCC ID: 2ABS2-SOSR1
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate this equipment.
Industry Canada (IC) Certified - Model: SOS, IC ID: 11740A-SOSR1
This device complies with Industry Canada License-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept interference, including any interference that may cause undesired
operation of this device.
SensorSafe
™
Technology
Questions? Comments?:
Visit us at: www.evenflo.com
Or call ParentLink at: 1-800-233-5921 (U.S.),
1-937-773-3971 (Canada), or
01-800-706-12-00 (Mexico).
Para instrucciones en Español, llamar al: 1-800-233-5921
The SensorSafe Receiver is designed to respond after the vehicle has been driven
for 30 seconds at 5 miles per hour or more.
Within 2 seconds of parking your vehicle and turning off the ignition you will hear
the SensorSafe reminder, alerting you that your baby is in the vehicle.
If you don’t hear the reminder tone, test your SensorSafe by following steps 1-5
again. Contact Evenflo’s ParentLink at: 1-800-233-5921 (U.S.), 1-937-773-3971
(Canada), or 01-800-706-12-00 (Mexico) if the reminder tone again fails to sound.
Drive the vehicle.
Park the vehicle and turn off the ignition.
4
5
1
3
2
4
5
7
8
6
WARNING
This product contains magnets.
Before use, consult your family doctor about the
compatibility of this product with pacemakers and similar devices.
For a period of 90 days from the original purchase of this Product, Evenflo warrants to the original end user
(“Purchaser”) this Product (including any accessories) against defects in material or workmanship. Evenflo’s
sole obligation under this express limited warranty shall be, at Evenflo’s option, to repair or replace any
Product that is determined to be defective by Evenflo and determined to be covered by this warranty.
Repair or replacement as provided under this warranty is the exclusive remedy of the Purchaser. Proof of
purchase in the form of a receipted invoice or bill of sale evidencing that the Product is within the warranty
period must be presented to obtain warranty service. This express limited warranty is extended by Evenflo
ONLY to the original Purchaser of the Product and is not assignable or transferable to subsequent purchasers
or end users of the Product. For warranty service, contact Evenflo’s ParentLink Consumer Resource Center at
www.evenflo.com.
EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ANY IMPLIED WARRANTY OF MERCHANTABILITY
OR FITNESS FOR A PARTICULAR PURPOSE ON THIS PRODUCT IS HEREBY DISCLAIMED. EVENFLO SHALL
NOT BE LIABLE FOR ANY INCIDENTAL, CONSEQUENTIAL, SPECIAL OR PUNITIVE DAMAGES OF ANY KIND
FOR BREACH OF THE EXPRESS LIMITED WARRANTY ON THIS PRODUCT, OR ANY WARRANTY IMPLIED
BY OPERATION OF LAW. OTHER THAN THE EXPRESS LIMITED WARRANTY SET FORTH ABOVE, THERE ARE
NO OTHER WARRANTIES THAT ACCOMPANY THIS PRODUCT AND ANY ORAL, WRITTEN OR ANY OTHER
EXPRESS REPRESENTATION OF ANY KIND IS HEREBY DISCLAIMED.
Limited Warranty
In order to comply with the FAA regulation
for Portable Electronic Devices (PED), the
SensorSafe Chest Clip
MUST
be unfastened
before take-off.
Note:
After landing, fasten the SensorSafe Chest
Clip before removing the Embrace Infant Car Seat
from the Aircraft seat.
When used on Aircraft: Unfasten SensorSafe Chest Clip
ARM
PIT LE
VEL
