66
67
Installing Child Restraint Forward-facing
in Aircraft
b
uck
le
storage
Forward-facing
Belt Path
4. Check your work.
With your hand holding the seat shell at the forward-
facing belt path, as shown, try to move the child
restraint from side to side. Then, holding the seat
shell at each forward-facing belt path, try to move
the restraint from front to back.
If you can move the child restraint more than 25
mm (1 inch) from side to side or front to back
at
the belt path
, the aircraft seat belt is not tight
enough, and you
MUST
install again until the
aircraft seat belt is tight.
•
DO NOT
lubricate or immerse in water the Lower Anchor
Connectors, the buckle, or any other part of this child
restraint, unless rinsing is permitted, as stated on the back
of the buckle for your restraint.
• Plastic and metal parts may be wiped clean with mild
soap and water and dried with a soft cloth.
Do not use abrasive cleaners or solvents.
• Take care not to damage any labels.
• Cup holder liners are dishwasher safe (top rack only).
• The harness can be wiped clean with mild soap and
water. Allow harness to air dry.
• Machine wash the seat pad separately in cold water,
delicate cycle. Tumble dry 10 to 15 minutes on low
heat.
•
NEVER
use child restraint without the seat pad.
• To protect the child restraint from damage caused by
weather, rodents, and other elements common to
garages, the outdoors, and other storage locations,
remove the seat pad and thoroughly clean the
restraint and pad prior to storage. Take care to clean
in the areas where crumbs and other debris tend to
accumulate.
Care and Cleaning
•
To help protect the
vehicle upholstery, place a
towel beneath and behind
the child restraint.
T
IP
!
T
IP
!
General
