Importer:
PHOYLO LTD, CZ684609501,
Enterprise House, Pass Street 2, 0L9 6HZ Oldham,
Manchester
, UK
Setting the basic parameters of the system:
To access the settings, turn off the LCD screen by pressing
(SW). Then turn the LCD on again by pressing (SW)
and immediately hold both buttons with symbols
(UP) and
(DOWN). After about 15 seconds a flashing
symbol with speed settings will appear. Individual values can be set by using the buttons and (UP) (DOWN). Switch
between the values by pressing the switch (SW). To exit and save the settings, hold (SW).
1. Setting the speed limit - the setting affects engine shutdown in the event of reaching the set speed. This
setting does not affect the maximum speed. The maximum speed that it reaches depends on the battery
voltage, the diameter of the wheel with the engine, the weight of the rider and the nature of the terrain.
The LCD panel is factory set to fully meet the legislative requirements for the operation of electric bikes on
the road. The speed is therefore limited to 25 km / h. This is the default setting. Please do not change when
you ride on roads.
2. Wheel diameter - to correctly measure the distance and speed, it is necessary to set the wheel diameter in
which the motor is installed. You can set these wheel diameters: 6, 8, 10, 12, 14, 16, 18, 20, 22, 24, 26, 700 C
and 28 inches. For the speed measurement the unit EVBIKE uses signals from the hall probes of the engine.
3. Unit settings - On the last screen you can set your preferred unit of measure for speed, distance and
temperature.
System
Metric
Imperial
Speed
km/h
MPH
Distance
km
Mil
Temperature
°C
°F
1.
2.
3.
NOTICE
Factory setings of the LCD panel fully meet the legislative requirements of the operation of road
electric bikes. The speed is therefore limited to 25 km/h.
