SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
6
BATTERY INSTALLATION
3
4
5
1
2
CAUTION
Before installing the battery, remove the key from
the Control Panel of your generator.
Set the battery holder on the frame and secure it with the
screw, washer and nut as shown in the drawing.
Place the battery on the battery holder.
Secure the battery using the brackets attach on the
battery holder.
Identify the red and black wires with positive and negative
electrodes of the battery.
Connect the red wire to the positive terminal of the
battery and the black wire to the negative terminal.
(See Fig.
ENGINE CONTROLS
Choke
CONTROL PANEL
Dipstick
120 VAC
Receptacle
OPS
20 A Overload
Protection System
120/240 VAC
Receptacle
Voltmeter
Digital
Hourmeter
Main Breaker
5-20P
L14-30P
ELECTRIC EXTENSIONS OR CORDS
All generator loads will be connected from the control
panel with extensions or cords with 3-prong grounded
plug for connection to 120 volts outlet and 4-prong
grounded plug for connection to 120/240 volts outlet.
See Table 3 for select the minimum cable gauge of
extensions or cords in agreement with the necessities
of the loads.
When the load increases must be used a cable extension
of greater size. Using extensions of inadequate size it is
in where can result in serious problems with the voltage,
reducing the electric energy applied to the tools and
causing damage on them.
As far as smaller is the number of the wire gauge greater
is the conduction capacity, an example is that A wire
gauge 14 for example can lead a current higher than a
wire gauge16.
When several extensions are connected it is a must to
review that each extension is of the minimum gauge
required.
If you need to use an extension with outlets to connect
more than one electric tool, sum the amperes marked in
the nameplates of each tool to determine the minimum
cord gauge you need to use.
The extensions for 120 volts are made of 3 cables where
the green cable is the grounding one, the white cable is
the neutral and the black cable is the hot wire.
1
2
3
4
5
6
7
8
The extensions 120/240 V are made of 4 cables where the
green cable is the grounding one, the white cable is the
neutral and the yellow cables are the hot wires.
UNPACKING
When umpacking check to make sure that all parts are
included. Refer to the General Assembly Drawing and
Parts List at the end of this manual.
If any parts are missing or broken, please call our
distributor.
Handle the battery carefully as it contains highly
corrosive acid and can cause burns. Never connect the
red wire to black, this can cause damage to physical
integrity and the equipment.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX
