Eurotech ANTARES, Руководство пользователя

Страница: 42 / 62

ANTARES - user manual
42
ETH_ANTARES_USM
Memory module installation
The ANTARES uses standard DDR3 DIMM ECC or non ECC memory modules. If only one memory
module is used, this can be plugged in to either memory slot 1 or 2.
To install a DIMM memory module into a DIMM socket, please follow the steps below:
1 Locate the DIMM sockets by placing the ANTARES on an anti-static pad with the solder side facing
up.
2 Align the DIMM module with the socket. The DIMM module must be oriented in such a way that the
notch in the middle of the DIMM module is aligned with the plastic bridge in the socket.
3 Insert the DIMM module by pushing it into the socket.
When the DIMM module is plugged in properly, the DIMM socket arms are closed, securing the
DIMM in the socket.
Jumper settings
Before the ANTARES is installed in the system, the jumpers must be set in accordance with the
desired configuration.
Information:
A jumper is a metal bridge used to close an electrical circuit. It consists of two or three metal pins and a
small metal clip (often protected by a plastic cover) that slides over the pins to connect them. To
CLOSE/SHORT a jumper means connecting the pins of the jumper with the plastic clip and to OPEN a
jumper means removing the plastic clip from a jumper.
Default jumper configuration: no jumpers fitted.
Clear CMOS Jumper
Jumper Label: JP1
If the ANTARES fails to boot due to improper BIOS settings, the clear CMOS jumper clears the CMOS
data and resets the system BIOS information. To do this, use the jumper cap to close pins 1 and 2 for
a few seconds then remove the jumper and place it back to pin 1.
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault may be
corrected by pressing the F1 button to enter the
CMOS Setup menu. Do one of the following:
•
Enter the correct CMOS setting.
•
Load Optimal Defaults.
•
Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.
The clear CMOS jumper settings (JP1) are shown in the following table.
Clear CMOS Description
Short 1 - 2 Clear CMOS setup.
Open 1 - 2 Keep CMOS setup (default).