EuroSteam Evolution 6399, Руководство пользователя, Страница: 6 / 7

-Remember steam can also be used on delicate fabrics.
- Crease lines for pants/slacks are best done on the ironing board for a nice sharp crease.
- No pressing cloth is required.
DRY IRONING (NOT AS DEMONSTRATED)
-
First make sure that there is no water in the boiler tank or stop the steaming by completely turning the steam
control knob (2) in a counter-clockwise direction.
-
Select the temperature best suited for the fabric by means of the thermostat knob. Fig. C. Refer to the table
below.
Note: This symbol on label means: this article cannot be ironed! (e.g. chlorofibre, elastodiene).
DRY IRONING CHART
HOW TO STORE EUROSTEAM EVOLUTION IRON
- Switch off the iron by turning the thermostat knob to “MIN”.
- Disconnect the plug from the outlet.
- Let out all the residual steam by using continuous steam.
- Let the iron cool down.
- Unscrew the safety cap (1) by means of the provided cap remover (3), overturn the iron and pour any remaining
water out of the boiler (Fig. F). Be careful of the hot water to avoid burns. This allows to always keep the boiler
tank well clean.
- When putting away the appliance at the end of the ironing session, do not screw the safety cap (1) down
completely but only by 3-4 turns.
- Turn the steam control knob in an anticlockwise direction until it stops, fully to the left side.
CLEANING
We suggest that these operations be carried out when water drops leaking out the soleplate are noticed, and in
any case every 3 months.
- To clean reservoir, pour equal portions of white vinegar and demineralized water into measuring cup, plug iron
in and leave cap off. The vinegar and water will boil in reservoir for 5-10 minutes.
- Empty the reservoir and refill with water. Give a good shake and empty water out.
Soleplate
- Before cleaning the iron, ensure that it is disconnected from the power supply and has completely cooled down.
- Do not use abrasives on the soleplate.
- Deposits and other residues on the soleplate can be removed with a rough cloth soaked in a vinegar and water
solution.
- Keep the soleplate smooth: avoid contact with hard and metal objects.
Boiler Tank
- Pour 1/4 cup vinegar and 1/4 cup distilled water into the boiler tank.
- Plug into outlet and set the thermostat control #9 setting.
- Let sit for 4-5 minutes, ans shake vigorously.
- Let cool for 10 minutes, push the steam push button until no more steam comes out and then unscrew and
empty.
This may need to be done several times depending on how long since last cleaning and type of water used.