43
•
•
•
•
•
•
•
•
•
42
EURO-9700 GOLD
This will take you to the following menu:
In this option, you need to enter the current PIN code at the first cursor, and at the
second cursor enter the desired PIN code.
To confirm, you need to enter the new PIN code again.
Please remember the PIN code that should be a 4-digit numerical value.
THE FACTORY PRESET PIN CODE:
0 0 0 0
.
N
N
N
N
O
O
O
O
T
T
T
T
E
E
E
E
:
If you forget the PIN Code, please refer to the following instruction:
1. Press
MENU
Key on the RCU.
2. Select “
Preferences
”.
3. Select “
System Information
”.
4. Press “
0000
” (A pop-up message appears that shows the password)
7.4
Receiver Lock
If you select “Locked”, you will have to enter the PIN code every time you start the
receiver from standby.
●
Press
/
keys to set the receiver lock.
5. TROUBLESHOOTING
Problem
Possible cause
Solution to the problem
The display LED at the front
Power cord is not plugged or
Check and plug the power cord properly.
panel is not illuminated.
inserted properly.
No power supply.
No video/picture at the
Receiver is in Standby mode;
Set the receiver to power “On”.
TV screen
RCA is not connected tightly
Check RCA cable connection
to receiver RCA connector.
and connect it properly.
Incorrect channel or video
Check the selected channel and video
input selected at the television
input and vary accordingly.
No sound
RCA cable is not connected
Check connection and correct it accordingly.
properly to receiver connector.
Volume level is set to minimum. Increase Volume level in both TV and receiver
Mute function is activated.
Press the MUTE key
The Remote Control
Incorrect remote control handing Point the remote control towards the Receiver
is not functioning.
Batteries are discharged or
Replace the batteries or insert them
inserted incorrectly
properly.
Poor / freezing picture quality
Signal strength to low
Check the signal strength in the “Auto Scan”
menu and align the dish properly.
On-Screen Error Message
Antenna cable is not tightly
Check the cable and tightened its
“Searching for signal”
connected.
connection
Defective LNB.
Change the LNB.
Incorrect alignment of the
Align the satellite antenna properly and
satellite antenna.
Check the signal strength in
“LNB POWER” is set to “Off”
the “Auto Scan” menu
in LNB setting menu.
On-Screen Error Message
No Satellite channel stored.
Select “Auto Scanning” or “Manual
“No programs are stored.”
Scanning” menu and do the scanning.
0922 EURO-9700 GOLD 10/2/03 12:50 PM Page 42
Содержание EURO-9700 GOLD
Страница 1: ...2...
Страница 24: ...47 MEMO MEMO 6...
