European Touch Solace ALTERA, Руководство пользователя

Страница: 16 / 24

Document ID:06080001 Rev: B Technical Support: 800-626-6912 Page 16 of 24
Crystal Clean
™
Pipe-Free
®
Spa - Operating Instructions
Preparing the Pedicure Spa for Operation:
After the pedicure spa is installed and the plumbing and electrical connections are made, clean and
disinfect the basin before initial use. Rinse the basin by using the attached water sprayer. Wipe the
basin dry with a clean towel.
To Operate the Pedicure Spa, Follow These Easy Steps:
Adding Water to the Pedicure Spa Basin:
1. Close the drain by turning the chrome drain handle counter-clockwise until it stops.
2. Add water to the basin by lifting upward on the water faucet fill handle. Turn the handle in a
counter-clockwise direction for cold water or clockwise for warm water as indicated by the red
(hot) and blue (cold) markings around the handle (CAUTION: hot water can burn skin). Continue
to add water until the fill line is reached. The fill line is indicated by the wavy (~~~~) line in the
basin.
3. Turn the off water by pushing the handle downward and center.
Operating the Crystal Clean
™
Pipe-Free
®
System:
The Crystal Clean
™
Pipe-Free
®
System eliminates pipes and jets that can harbor harmful bacteria
while at the same time delivering a soothing, quality foot massage. This unique system is driven by
an impeller that pulls water through the inlet cover and then forces the water outward through key
massage zones in the footplate. The end result is a soothing massage delivered to all areas of the
foot: front, back and bottom.
To start or stop the whirlpool, depress the On/Off button labeled “Jets” ( NOTE: An indicator light on
the “Jets” button flashes when the footplate is improperly installed, or the basin contains no
water. As a result, the whirlpool will not function. To fix, simply check that the footplate is
securely fastened or add water to the basin
).
Removing Water from the Pedicure Spa Basin:
First, make certain the whirlpool jets are turned off by turning the On/Off switch counter-clockwise to
the “Off” position.
If the pedicure spa is hooked up directly to a floor drain, simply open the drain by turning the drain
handle in a clockwise direction until it stops. You should see the water level lowering as water exits
the basin.
If the pedicure spa is equipped with the optional Power Drain Pump (PDP) feature, open the drain by
turning the drain handle in a clockwise direction until it stops. Press the button marked “Drain” on the
front panel. The water level will lower as water is pumped out of the basin. Turn the pump off by
pressing the “Drain” button on the front panel once the basin is fully drained (
NOTE: the PDP will
automatically shut off after 2-1/2 minutes. We recommend turning off the pump manually if all
water has drained before automatic shut-off
).
Warning:
It is extremely important to follow the cleaning instructions located on the following page.
Failure to clean the pedicure spa adequately can result in serious health issues for your
clients as well as the nail technician. Failing to clean your pedicure spa may also cause the
pedicure spa to not work properly. Please consult your local and state codes concerning
pedicure chair cleaning for further requirements.