Doc ID: 01080001
Revision: F
Technical Support: 800-626-6912
Page 13
P
ETITE
S
PA
™
-
C
LEANING AND
D
ISINFECTING
P
ROCEDURES
Always check with your state board for required cleaning and disinfecting procedures.
It is extremely important to clean and disinfect your pedicure spa
after each pedicure, after the last
pedicure of the day, and once a week for overnight cleaning
. Regular cleaning will help keep your
pedicure spa in good working condition. Proper and continuous cleaning will kill harmful bacteria and
germs that can cause infection.
To clean the pedicure spa, follow these easy steps:
After Each Pedicure:
1. Drain water from the pedicure spa by turning the drain handle to the “Open” position.
Remove
all debris
.
2. Clean all the surfaces of the basin and all components. Use low-sudsing soap or detergent, and
a non-abrasive brush. Remove all visible residue from basin and then rinse with the sprayer.
3. Disinfect all surfaces and components with an EPA registered disinfectant in accordance with
your state board requirements.
*EPA disinfectants require ten-minute contact
.
4. Rinse off with clean water using the sprayer and wipe all parts dry with clean towel.
After Last Pedicure of the Day:
1. Drain water from the pedicure spa by turning the drain handle to the “Open” position.
Remove
all debris.
2. Remove the following:
a. Drain cover as shown on page 21.
b. Suction cover as shown on page 20.
c. Jets as shown on page 20.
3. Remove all debris then wash each component with low-sudsing soap, or detergent, using a soft
brush. Disinfect the components as well as the areas behind them with an EPA registered
disinfectant. Follow your state board requirements for disinfecting. Replace all components.
4. Clean all the surfaces of the basin using low–sudsing soap or detergent, and a non-abrasive
brush. Remove all visible residue from basin and then rinse with sprayer.
5. Fill basin with clean warm water to the fill line.
6. Pour into the basin
three teaspoons
of low-foaming dishwasher crystals (not gel) and
1 ounce
of household bleach for up to six gallons of water.
Follow your state board requirements as they may differ from the above step.
7. Turn on the whirlpool jets and let run for ten minutes.
8. Turn the jets off and drain water from the basin.
9. Rinse the basin and all other components with clean water using the sprayer.
10. Refill the basin with clean water. Turn the jets on and run for one minute.
11. Drain water from the basin and turn off the whirlpool jets. Then wipe dry with a clean towel.
12. Make a record of the date and time of this cleaning and disinfecting.
Once a Week Overnight Cleaning:
In addition to the daily cleaning, the following cleaning procedures must be done every week.
1. Follow
steps
one through seven
as listed above as in “After Last Pedicure of the Day.”
2. Turn jets off after ten minutes and
let solution sit over night in basin (six to ten hours).
3. The next morning drain, rinse, and wipe dry with a clean towel.
4. Make a record of the date and time of this cleaning and disinfecting.
CAUTION: Cleaning products that contain abrasives can damage the pedicure spa. Use ONLY
non-abrasive products to clean the pedicure spa.
