43
MAINTENANCE
Element4 Gas Fireplaces
European
Home
.com
REMOVING AND CLEANING THE GLASS
Step 1.
Remove all of the trim pieces (magnetically attached) from the
fireplace. See Figure 46. The Sky T has two glass panels, therefore,
twice the number of trim pieces. There is no top trim on either
fireplace. The trim pieces are held firmly in place with magnets and
will simply lift out. The bottom (horizontal) trim pieces are at the
lower edge of the glass panels and the side (vertical pieces) are
where the glass meets the wall.
Step 2.
Each glass panel is held in place by three gasketed glass clamps on
either side. Remove the retaining bolt(s) holding the glass clamps
and then remove the clamps. See Figure 47.
Step 3.
Securely attach a vacuum glass clamp to the glass in the approximate
center and lift the glass up into the clearance notch.
With the glass panel raised into the upper rail, swing the lower edge
of the glass panel out towards the room and gently lower the glass
towards the floor until it clears the fireplace. See Figure 48.
Step 4.
Repeat Steps 2 and 3 for the other glass panel, if present.
REMOVING THE GLASS
• No. 2 Phillips screwdriver (not included)
• a vacuum clamp (included)
TOOLS REQUIRED
The glass panel(s) are held in place by two gasketed clamps (one on
either side with two bolts each) and a rope gasket at the lower edge
of the glass. These instructions require two technicians and will
show you how to remove and install the glass panel(s).
Please read these instructions completely before proceeding.
OVERVIEW
Figure 46
Side Trim
Bottom Trim
Figure 47