European Home Gas Stones Vent Free, Инструкция по установке, эксплуатации и обслуживанию, Страница: 18 / 28

18
FOR YOUR SAFETY READ BEFORE LIGHTING!
A. This heater is equipped with an ignition device which automatically lights the pilot. Do not try
to light the pilot by hand.
B. BEFORE LIGHTING smell all around the heater area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s
instructions
• If you cannot reach your gas supplier, call the fire department.
C. Do not use this heater if any part has been under water. Immediately call a qualified service
technician to inspect the heater and to replace any part of the control system and any gas control
which has been under water.
WARNING:
If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
OPERATING INSTRUCTIONS
RESETTING THE SYSTEM (Synchronizing the Remote and Receiver)
Before the first fire the remote control and receiver must be synchronized. This is accomplished by
resetting the system as follows:
1. press and hold the receiver RESET button until you hear the second of two beeps then
2. release the RESET button and, within twenty seconds,
3. press the SMALL FLAME button on the remote until you hear a confirming beep. Release
the down button.
The receiver and remote are now each synchronized and ready for normal operation.