REVERSING THE DOOR SWING OF YOUR APPLIANCE FOR EWC 6460S/EWC 6110S/EWC 6155S
This wine cellar has the capability of the door opening from either the left or right side. The unit is delivered
to you with the door opening from the left side. If you desire to reverse the opening direction, follow the
following reversal instructions:
NOTE:
All parts removed must be saved to allow the door swing to be reversed.
Follow these steps:
1. Open the glass door and remove the two lock screws holding the lower hinge to the glass door. Be
careful to hold the glass door firmly after removing the screws.
2. Pull up to remove the glass door and place it on a padded surface to prevent scratching it. Install the
two screws back to the two holes of the door bottom at right side.
3. Remove the right lower hinge supporter.
4. Remove the door axle from the right upper hinge then install and tighten it in the left upper hinge.
5. Take the left lower hinge bracket from the left side then install it at the designated position.
6. Remove the two screws from the door bottom at left side, set the glass door to the designated position
and install the two screws to connect the lower hinge with the glass door and tighten them before the
door is levelled.
7. Remove the handle from the left side of the door and install it on the right side of the door.
Lock screws
Lower hinge
Bush
Lower hinge bracket
Glass door
Door axle
1
2
3
4
5
6
8
INSTALLATION INSTRUCTIONS
