Page
1 of 2
EDS
1074-001
SET
CodE
Set
Set
The first digit of the bottom box will be
flashing.
Use the side arrow to move to next digit.
Use up arrow to change digit in sequence.
Enter
0101.
Press return twice. (only)
Display should now read code in top line.
Lines two and three should be blank.
Set Display Line At Start Up:
This chooses what is displayed when the meter is first switched on. As default it is the single phase voltage.
Up Arrow
Set
Set
Default Display Setting 1-7:
0001 =
Volts
0003
= Amps
0002 =
3 Phase Volts
0004
= Kw
0005 =
Frequency
0006
= Ept
0007 =
Eqt
Press return twice
.
To Enable Changes To Meter Follow This Programming Sequence:
Three Phase Board Meter Instructions:
The meter has already been programmed and is ready to use, but should the meter need to be re-programmed in order to add other features then
the following process should be followed. Before a setting can be changed the meter has to be entered into programme mode.
Display
Meaning
Display
Meaning
CodE
Code
pur
Code Input
chAG
Change Code
sEr
Set
clt.E
Energy Clearance
diSP
Display
-Sn-
Instrument Address
In.Pr
Signal Input
Conn
Communication
n.8.1
Data Bite 8, Stop Bite 1, No. Check
n33
3 Wire 3 Phase
E.8.1
Data Bite 8, Stop Bite 1, Even Parity
n34
3 Wire 4 Phase
o.8.1
Data Bite 8, Stop Bite 1, Odd Parity
nEr
Network
bAUd
Baud Rate
-pr-
Voltage Ratio
-Cr-
Current Ratio
dArA
Data Format
F
Frequency
EPt
Positive Active Power
E9t
Positive Reactive Power
Technical Data:
TPNMM
Clear Energy Display (Reset):
Clears display.
Press set button three
times, energy will be
reset to zero
.
CodE
Pur
Set
CodE
Pur
0000
CodE
Pur
0101
CodE
SEr
SEr
dISP
SEr
dISP
0000
Up Arrow
Set
Up Arrow
CodE
SEr
SEr
cLRE
SEr
cLRE
0000
