6
Mounting the AI3000 receiver
The AI3000 receiver comes with a trunnion mount to secure to a bulkhead or shelf
Select a location away from excessive heat sources, such as heating vents or
equipment heat exhausts and avoid areas where there is a high flow of moisture or
humid salt air (e.g. port holes/windows, and hatches that are open to the outside) and
high levels of vibrations and shocks.
Rear view of the AI3000
Connections
Power
Connect the power lead to a 12 or 24 volt DC supply. This should be connected to a
breaker switch panel preferably with a fuse rated 1 Amp. Pin connections are shown
below.
Pin 1 RED
+ Positive 9 to 30 volts
Pin 2 BLACK
- Negative
Data
The data connector enables one of the two cables supplied to connect either to a PC
serial port (or USB port by using a suitable USB - serial adapter cable) or a NMEA
device e.g. plotter or GPS.
Physical connections detail of both cables is provided overleaf.
