16
Assembly, location and connection
Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact
your vendor for inspection or replacement.
Attach the two feet to the heater using 2 x 2 screws, as shown on the drawing.
Make sure that the pins on the housing slot into the recesses in the feet!
Choose a suitable location for the heater, i.e. at least 1,5 metre away from any
obstructions, walls or inflammable materials (see also safety instructions).
Make sure the heater is always in an upright position on a solid, flat, horizontal
and non-flammable surface.
Make sure the heater is switched off (switch to O position), then plug into a
correctly functioning 220-240V/50Hz socket. Only connect the heater to an
earthed
socket!
By now pressing one of the switches, you turn the heater on at half output
(400W); by pressing both switches, the full output (800W) is switched on. By
turning the switches back to O, you switch the heater off.
Never use the heater without feet!
Safety features
The heater is fitted with a
tipping safeguard
which automatically shuts off the
appliance if it inadvertently falls over. When the heater is returned to its upright
position, it will resume functioning as normal but, before reusing, switch off, unplug
and check for damage. Do not use the heater if it is damaged or malfunctioning, but
have it inspected/repaired!
