EN
127
made, the tap should be turned on ful-
ly and checked for water tightness. For
the safety of your machine, make sure
to always turn o
ff
the water inlet tap after
each wash programme is
fi
nished.
NOTE:
Aquastop
water spout is used
in some models.
In case of using
Aquastop, a danger-
ous tension exists.
Do not cut Aquastop
water spout. Do not
let it get folded or
twisted.
2.4 Water connection
We recommend
fi
tting a
fi
lter to your
water inlet supply in order to prevent
damage to your machine due to con-
tamination (sand, rust, etc.) from indoor
plumbing. This will also help prevent
yellowing and deposit formation after
washing.
Note printing on the water inlet hose!
If models are marked with 25°, the water
temperature may be max. 25 °C (cold
water).
For all other models:
Cold water preferred; hot water max.
temperature 60 °C.
2.5 Water outlet hose
The water drain hose can be connected
either directly to the water drain hole or
to the sink outlet spigot. Using a special
bent pipe (if available), the water can be
drained directly into the sink via hooking
the bent pipe over the edge of the sink.
This connection should be at a minimum
of 50 cm and and at a maximum of 110
cm from the
fl
oor plane.
Warning:
When a drain hose longer
than 4 m is used, the dishes might re-
main dirty. In that case, our company will
not accept responsibility.
2.6 Electrical connection
The earthed plug of your machine should
be connected to an earthed outlet sup-
plied by suitable voltage and current. If
there is no earthing installation, have a
competent electrician carry out an earth-
ing installation. In case of usage without
earthing installed, our company will not
be responsible for any loss of usage that
might occur.
The indoor fuse current value should be
10-16 A.
Your machine is set according to 220-
240 V. If the mains voltage in your loca-
tion is 110 V, connect a transformer of
110/220 V and 3000 W inbetween. The