134
EN
If there are whitish stains on the
dishes
• A very small amount of detergent is
being used.
• Rinse aid dosage setting at a very low
level.
• No special salt is being used despite
the high degree of water hardness.
• Water softener system setting is at a
very low level.
• Salt compartment cap not closed well.
If the dishes won't dry up
• A programme without a dry operation
selected.
• Rinse aid dosage set too low
• Dishes unloaded too fast.
If there are rust stains on the dishes
• Stainless-steel quality of the dishes
washed is insu
ffi
cient.
• High rate of salt in the wash water.
• Salt compartment cap not closed well.
• Too much salt spilt into the sides and
into the machine while
fi
lling it with
salt.
• Unhealthy mains grounding.
Door is not opened / closed properly;
• Not proper weight wooden part
inserted on the door. ( Follow the
weight given in the Assembly manuel)
• The tensile of the door spring not
adjusted properly. Adjust it according
to the Assembly manuel
Call an authorised service if the
problem still persists after the
controls or in case of any malfunction
not described above.
9. PRACTICAL AND
USEFUL INFORMATION
1. Whenever you will not be operating
your machine
• Unplug the machine and then turn the
water o
ff
.
• Leave the door slightly ajar in order
to prevent the formation of unpleasant
smells.
• Keep the machine interior clean.
2. Eliminating water droplets
• Wash the dishes with the intensive
programme.
• Take all of the metal containers in the
machine out.
• Do not add detergent.
3. If you properly place your dishes into
the machine, you will be using it in the
best way in terms of energy consump-
tion, washing and drying performance.
4. Clean all rough waste before you
place dirty dishes to the machine.
5. Operate the machine after it is com-
pletely full.
6. Use pre-washing program only when
necessary.
7. Observe program information and av-
erage consumption values table when
selecting a program.
8. Since the machine will reach high
temperatures, it should not be mounted
near refrigerator.
9. If the appliance is located in a place
where the risk of freezing exists, you
must completely drain the water that
has remained in the machine. Turn o
ff
the water tap, disconnect the water inlet
hose from the tap and allow the interior
water to drain.