Eurolux DW9-CBE, Инструкция по эксплуатации и гарантия

Страница: 18 / 28

17
en
Memory Function Module
If a current leak happens while the selected washing program is active, the program is not cancelled.
The controls use a microprocessor device, to memorize the information about the selected washing
program. Once the machine is again powered on, the dishwasher will be resumed from the point it was
interrupted.
Canceling or modifying a washing program cycle
1:To modify or cancel the carrying out of a washing cycle (being the door opened), it's necessary to
reset the previous programming, by holding pushed the programme selector button “E” for at least 3
seconds, and the buzzer emits one short warning signal.
2:If the reset operation was successful, a drain phase is started. Once the drain phase is ended, the
dishwasher stands waiting for a new programming
3:A cycle that is underway can be modified if it has only been running for a short time. Otherwise, the
detergent may have already been used, and the appliance may have already drained the wash water. If
this is the case, the detergent dispenser must be refilled.
B E
1 /2 Load Button
T his button ì Bî (see" Close-up View (Control Panel) ) makes it possible to wash dishes using only the
upper rack if there are not enough dishes for a full load. This will allow you to save on water and energy
consumption.
T o select 1/2 load:
S elect the programme ( see the paragraph entitled Switching the dishwaher ON)
Press the 1/2 load button ì Bî , 1/2 load indicator blinks.
Close the door, and the programme starts automatically.
T o cancel the 1/2 load
P ress programme button ì Eî a nd hold it in for about 3 seconds.
- Please keep in mind that the amount of detergent should also be adapted to the 1/2 load.