Eurolux DW12-CBE7, Инструкция по эксплуатации

Страница: 10 / 36

9
en
Insert the top hooks into the appropriate slots in the dishwasher
control panel. Then push the panel upwards until it stops. After-
wards , slide the panel downward again, moving the bottom of the
panel toward the door so that the fins on the brackets slide into
their slots (see Fig.3).
Open the doors of the dishwasher (the panel should stay in place
by itself) and align the panel with the door, keeping it in contact
with the control panel. Remove the small plastic plugs that cover
the holes on the inside of the dishwasher door and fasten the panel
in place with the screws provided (see Fig.4). Remember to cover
the two holes with the plastic plugs removed earlier.
Installation of Continuous Base Moulding
Position the washing machine in the cut-out in the kitchen cabinet:
1. Install the continuous base moulding, following the manufacturer’s
instructions.
2. Slowly open the door of the dishwasher to check to see if the
door strikes or rubs against the base moulding.
3. If so, rest the bottom edge of the panel on the base moulding
and mark the part to be cut. Leave at least 3 mm of the play
between the panel and the base moulding to allow for the door to
rotate freely (see Fig.6).
4. Remove the base moulding and trim it as needed, protecting the sur-
face that has been cut with a paint or similar wood finish (see Fig.6).
5. Install the base moulding again (see Fig.7).
Fig.4
2-7Kg
Fig.3
A
B
2Kg
7Kg
Fig.5
Fig.6
Fig.7
The door must be perfectly balanced. In the factory , the tension
of the springs is regulated to ensure that the door is perfectly
balanced when light wood door panels are mounted on the door.
If heavier, solid wood door panels are used, the door can be bal-
anced by simply turning the two screws (both screws must be
turned the same amount) located on the top part of the machine.
Adjusting the Door Springs (see Fig.5B)
Adjustment of Back Feet (see Fig.5A)
Insert the appliance in the cutout and then adjust the height of the
machine using the screws located at the bottom front .Use a screw-
driver to turn the screws in a clockwise direction to raise the dish-
washer and in an anticlockwise direction lower it.