20
Occupation of the DIP-switches:
Projector 1 - channels 1-4
On
Off
Starting address
Projector number
& channels
Off
Projector 2 - channels 5-8
On
Off
Projector 3 - channels 9-12
On
Off
Projector 4 - channels 13-16
On
Off
Projector 5 - channels 17-20
On
Off
1
2
4
8
16
32 64 128 256
DIP-switch no.
1
2
3
4
5
6
7
8
9
Setting the DMX-
starting address:
Connection with the mains
This device falls under protection-class I. The electric connection must be carried out by a qualified
employee.
Connect the fixture to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable
Pin
International
Brown
Live
L
Blue
Neutral
N
Yellow/Green
Earth
The earth has to be connected!
In general, lighting effects should not be connected to dimming-packs.
OPERATION
After you connected the effect to the mains, the TS-3 starts running. During the Reset, the motors are
trimmed and the device is ready for use within approximately 20 seconds.
Sound-control/Master/Slave-operation
The lamp is automatically ignited as soon as the condensor microphone receives music signals. If the
projector does not react to the music signals, the microphone sensitivity is too low. You can adjust the
sensitivity with the rotary-control on the rearpanel.
You can do without a controller as the TS-3 features a built-in microphone, which provides automatic sound
control.
If you have connected a footswitch to the Blackout-socket, you can lock the light output (Blackout-mode) and
turn it on again.
Please note:
If you wish to change from one operating mode into another, you either have to switch off the
lamp/activate Blackout-mode or unplug the projector from the mains and plug it again.
