EuroLite TR-5, Руководство пользователя

Страница: 24 / 55

51785863_V_1_1.DOC 24/55
A safety rope which already hold the strain of a crash or which is defective must not be used again.
Adjust the desired inclination-angle via the mounting-bracket and tighten the fixation screws.
DANGER TO LIFE!
Before taking into operation for the first time, the installation has to be approved by an expert!
DMX-512 connection / connection between fixtures
DMX-512 Controller
120 Ohms
1: Ground
2: Signal (–)
3: Signal (+)
XLR occupation:
In Out
Safety-rope
www.eurolite.de
Sensitivity
Microphone
MADE IN CHINA
0,5 m
F
T =45° C
a
T =80° C
B
Type: TR-5 DMX-Flower-Effect
Power supply: 230 V AC, 50 Hz ~
Power consumption: 300 W
Fuse: F 3.15 A, 250 V
Lamp: EHJ 24 V/250 W G-6.35
®
eurolite
www.eurolite.de
1: Ground
2: Signal (–)
3: Signal (+)
XLR occupation:
In
Out
Safety-rope
www.eurolite.de
Sensitivity Microphone
MADE IN CHINA
0,5 m
F
T =45° C
a
T =80° C
B
Type: TR-5 DMX-Flower-Effect
Power supply: 230 V AC, 50 Hz ~
Power consumption: 300 W
Fuse: F 3.15 A, 250 V
Lamp: EHJ 24 V/250 W G-6.35
®
eurolite
www.eurolite.de
1: Ground
2: Signal (–)
3: Signal (+)
XLR occupation:
In Out
Safety-rope
www.eurolite.de
Sensitivity Microphone
MADE IN CHINA
0,5 m
F
T =45° C
a
T =80° C
B
Type: TR-5 DMX-Flower-Effect
Power supply: 230 V AC, 50 Hz ~
Power consumption: 300 W
Fuse: F 3.15 A, 250 V
Lamp: EHJ 24 V/250 W G-6.35
®
eurolite
www.eurolite.de
Projector 1
Starting address 1
Projector 2
Starting address 3
Projector 3
Starting address 5
The wires must not come into contact with each other, otherwise
the fixtures will not work at all, or will not work properly.
Connection with the mains
Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable Pin International
Brown Live L
Blue Neutral N
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
Lighting effects must not be connected to dimming-packs.
OPERATION
After you connected the effect to the mains, the TR-5 starts running. During the Reset, the motors are
trimmed and the device is ready for use afterwards.
Turn the objective-lens for adjusting the focus in order to obtain a sharp projection.