00055404.DOC, Version 2.0
17/20
INSTALLATION
Installing/Replacing the lamp
DANGER TO LIFE!
Only install the lamp with the device switched off!
Unplug from mains before!
The lamp has to be replaced when it is damaged
or deformed due to the heat!
CAUTION!
Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 5 minutes).
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
During the operation, the lamp reaches temperatures of up to 650° C.
For the installation, you need a 230V/2000W GY-16 lamp.
Procedure:
Step 1:
Unscrew the fixation-screw of the protection-cover on the rear of the housing.
Step 2:
Remove the protection-cover.
Step 3:
If replacing the lamp, remove the old lamp from the socket.
Step 4:
Insert the 230V/2000W GY-16 lamp into the lamp-socket.
Step 5:
Replace the protection-cover and tighten the screw.
Do not operate this device with opened protection-cover!
Overhead rigging
DANGER TO LIFE!
Please consider the EN 60598-2-17and the respective national standards during the installation!
The installation must only be carried out by an authorized dealer!
The installation of the device has to be built and constructed in a way that it can hold 10 times the weight for
1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down
if the main attachment fails.
When rigging, derigging or servicing the device staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.