00074229, Version 1.0
24/27
Setting the Sound Sensitivity:
You can do without a controller as the device features a built-in microphone, which provides automatic sound
control.
Manual adjustements via display as follows:
Mode:
Value:
Sensitivity:
S
S00-S99
Increasing sensitivity
You can select the desired sensitivity via the UP or DOWN buttons.
Please press the ENTER button to confirm and then the MODE button to attain the main menu.
DMX MODE
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED ML-56 RGB 36x3W will respond to the controller.
Addressing
Press the MODE button until the display shows
ADD
. You can now set the desired address via the UP or
DOWN buttons.
Please press the ENTER button to confirm and then the MODE button to attain the main menu.
Setting the DMX Start Address:
Mode:
Value:
ADD
001 - 512
Controlling:
After having addressed the LED ML-56 RGB 36x3W , you may now start operating it via your lighting
controller.
Note:
The modes of DMX 512 data are shown via the DMX indicator.
After switching on, the device will automatically detect whether DMX 512 data is received or not. If the data
is received, a point will blink on the display.
If there is no data received at the DMX-input, the point will not blink.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective,
- the cable or connector is defective or the signal wires are not properly connected with the input connector.
