00048182.DOC, Version 1.1
22/26
Please press the ENTER button to confirm and to exit the AUTO Mode.
DMX MODE
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED Flood Light / Bar PIX-24 RGB will respond to the controller.
Controlling:
After having addressed the LED Flood Light / Bar PIX-24 RGB, you may now start operating it via your
lighting controller.
Note:
It’s necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order
to ensure proper transmission on the DMX data link.
Addressing
Press the MODE button until the display shows DMX MODE.
Press the ENTER button and the display shows: 001.
Set the desired address via the UP or DOWN buttons.
Please press the ENTER button again to confirm and to select a DMX Channel Mode.
DMX Channel Selection : Choosing a DMX Channel Mode up to 27 Channal Occupation
After having set the desired addresses and pressed ENTER, you can now choose a DMX Channel Mode. (6
CH, 9 CH, 15 CH, 24 CH, 27 CH).
Set the desired mode via the UP or DOWN buttons.
Press the ENTER button again to confirm and to exit the DMX Mode.
Please see the following DMX protocol graphic for the respective channel values.
DMX-Protocol
The LEDs of the devices are separated into 8 segments which can be controlled in the following 5 different
modes.
EUROLITE LED Flood Light PIX-24 RGB
51913883
EUROLITE LED Bar PIX-24 RGB
51930215
