00090020.DOC, Version 1.0
21/23
MODE UP DOWN ENTER
Master/Slave operation
The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the device you can find an XLR jack and an XLR plug, which can be used for
connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX-cable. Connect the OUT jack
with the IN plug of the next device.
Set the desired Master-mode - „Sou1, Sou2 and Au00“ - for the master-device, as described in chapter
Control Board. Set the DMX address 001 for all slave-devices.
OPERATION
After you connected the LED Strobe COB PRO 8x20W DMX to the mains, it starts running.
The LED display lights up and you can choose the desired mode via the buttons MODE, UP, DOWN and
ENTER.
The device has two operating modes. It can be operated in Stand Alone via LED display with operating
buttons or in DMX-controlled mode via lighting controller.
Stand-alone Mode
In the Stand Alone mode, the device can be used without a controller. Disconnect the device from the
controller.
Control board
The control board offers several features, i.e. setting the DMX starting address, running
a preset program or selecting a DMX channel mode.
Browse through the menu by pressing MODE. You can change the selection by
pressing UP or DOWN. Press ENTER in order to confirm. You can leave every mode by
pressing MODE. The functions provided are listed in the following sections.
The display shuts off after 30 seconds of inactivity. With the touch of a button it lights up again.
Display Setting
Function
A001
001-512
DMX address setting
With this function, you can adjust the desired DMX-address
via the Control Board.
dISP
Yes
Display reverse 180 degree
With this function you can flip the display by 180° for a better
view when the fixture is hung from the truss or a ceiling.
LOdA
YES/NO
Restore factory settings
With this function you can restore the factory settings of the
device.
Sou1
Music controlled program 1
With this function, you can run the music controlled program
1 (single flash) sound-controlled.
Sou2
Music controlled program 2
With this function, you can run the music controlled program
2 (double flash) sound-controlled.
Au00
Au00-Au16
Auto program
With this function you can select the Auto program in 17
different speeds (increasing).
