00095340.DOC, Version 1.1
14/16
INSTALLATION
Attachment
Permanent installation is recommended!
Before attaching the device, make sure that the installation area can hold a minimum point load of 10 times
the device's weight.
The device must only be installed absolutely planar at a vibration-free, oscillation-free and fire-resistant
location. Make sure that the device is installed absolutely planar by using a water-level.
The device must be installed out of the reach of people.
The device must always be installed via all fixation holes. Do only use appropriate screws and make sure
that the screws are properly connected with the ground.
The durability of the installation depends very much on the material used at the installation area (building
material) such as wood, concrete, gas concrete, brick etc. This is why the fixing material must be chosen to
suit the wall material. Always ask a specialist for the correct plug/screw combination indicating the maximum
load and the building material.
Procedure:
Step 1:
The hole for the installation is on the mounting bracket.
Step 2:
Hold the mounting bracket onto the location where the device is to be installed.
Step 3:
Mark the borehole with a pen or a suitable tool.
Step 4:
Drill the hole.
Step 5:
Hold the mounting bracket in the desired position and fix it.
Step 6:
Adjust the desired inclination-angle via the mounting-bracket and tighten the fixation screws.
OPERATION
Battery Operation
The device features a rechargeable lithium battery for cable-free operation. Prior to initial use, completely
charge the battery.
1
Connect the charger to the power input at the device and the mains plug to a mains outlet (100-240 V
AC, 50/60 Hz). The indicator light on the charger turns red while the battery is charging, then it turns
green when the battery is done charging. The battery can be charged before, during or after operation.
To charge the battery with the LED off, leave the power switch in the off position.
2
The device features a protective circuit for charging which prevents overload of the rechargeable battery.
However, disconnect the device from the mains after charging. Otherwise there will be a low current
consumption even if the device is switched off.
3
The device will heat up during charging; this is normal.
4
To prevent damage to the battery by deep discharge, recharge a battery completely discharged as soon
as possible. Do not store the unit with the battery completely discharged and regularly recharge the
battery in case of long storage.
Maximum battery run time
Recharge time
4 hours
4.5 hours
