00134564, Version 1.0
23/28
Green
000-255
Green, increasing intensity
Blue
000-255
Blue, increasing intensity
White
000-255)
White, increasing intensity
Device
Information
Info
RunTime
0000-9999
Operating hours of the device
Tempera
XXX
Inner temperature
DivVers
V0.01
Software version
Interconnecting several devices (master/slave operation)
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1 Configure all slave units before connecting the master unit: Set the DMX address to A001 for all slave
devices. Confirm with the
ENTER
button.
2 Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
3 Set the master unit to the desired operating mode (under Run Mode: Auto oder Sond). The
interconnected devices will now operate in synchronously.
DMX operation
Setting the number of DMX channels and the DMX starting address
For operation with a controller with DMX512 protocol, the device is equipped with 54 control channels.
However, it can also be switched to a mode with 5 or 13 channels if different functions are required. To be
able to operate the device with a DMX controller, the DMX starting address must be set. The starting
address depends upon which DMX controller is being used. Please refer to the controller’s documentation.
1 Press the
MUSE
button so many times until
Address
is indicated on the display. Confirm with the
ENTER
button.
2 Now the display indicates the menu item for the DMX start address
001-512.
Use the buttons
UP
and
DOWN
to set the address. Confirm with the
ENTER
button.
3 Now press the
UP
button so many times until
Channel
is indicated on the display. The display indicates
the menu item for the DMX channel modes:
5CH
(5 DMX channels),
13CH
(13 DMX channels) or
54CH
(54 DMX channels). Confirm with the
ENTER
button. Use the buttons
UP
and
DOWN
to select the
desired DMX channel mode. Confirm with the
ENTER
button.
4 A dot will light up when DMX signals are being received. If no control signals are available, the dot will
flash.
Note: Please make sure that you do not have any overlapping channels in order to control each device
correctly and independently from any other fixture on the DMX chain. If several devices are addressed
similarly, they will work synchronically.
