During an unlock attempt, the battery gauge will indicate the system is
in a Locked state by flashing LEDs 1, 3, and 5 (far left, middle, and far
right) until either the system is powered off, unlocked, or the Sequence
Timeout is reached.
The lock function is only available when the
Enable Lock
parameter is set to
Yes
;
The horn will not sound when pressing the Horn button during the
unlocking sequence.
●
The battery gauge
The battery gauge comprises five different LEDs
(1 x RED, 2 x AMBER, 2 x GREEN), situated
above the Remote's Horn button. The number
of LEDs lit depends on the status of the
battery, as shown below.
The battery gauge LEDs are also used to
display charging information. See section 7.2
Battery charging for more details.
The battery gauge
Normal operation
Battery Gauge
Battery Level
Notes
Fully charged
This level is set by the Battery
Gauge Maximum parameter.
Batt Gauge Maximum.
Consider charging battery
Battery needs charging This level is set by the
Battery Gauge Minimum
parameter.
Battery Gauge Minimum.
Battery gauge operation
This battery gauge is setting based on SLA battery, for lithium
battery will need to reprogram for meet with its voltage.
- 29 –
●
High voltage warning
A high voltage warning is indicated by all LEDs on,
and the green LEDs flashing. This occurs when the
battery voltage level has risen above the high
voltage warning set-point.
High voltage warning
●
Low voltage warning
A low voltage warning is indicated with the left-
most LED flashing. This occurs when the battery
voltage level has decreased below its low voltage
warning set-point.
Low voltage warning
Charge the battery immediately - it is being damaged.
●
Cut-off voltage
When the battery voltage decreases below the battery cut-off
voltage:
l
the status indicator will flash ( Flash code 2)
l
the first (red) LED will flash on the battery gauge
l
the horn will sound once every 10 seconds
The status indicator
The status indicator is located underneath the power
button. When the System is not powered up, the status
indicator is not lit.
When the System is powered up, and there are no
faults with the system, the status indicator will be lit
green.
If, when powered up, there is a fault with the system,
then the status indicator will flash red. The number of
flashes will indicate the type of error.
The status indicator
- 30 –
