EUROCOM Sky MX5, Руководство пользователя

Страница: 219 / 326

Troubleshooting
Problems and Possible Solutions 7 - 9
7
Nothing appears on screen. The system is in a power saving mode . Toggle the sleep/resume key
combination, Fn + F12 (see “Configuring the Power Buttons” on page 3 - 9 ).
The screen controls need to be adjusted. Toggle the screen control key
combinations Fn + F8/F9 . If you’re connected to an external monitor, make sure
it’s plugged in and turned on. You should also check the monitor’s own
brightness and contrast controls.
The computer is set for a different display. Toggle the screen display key
combination, Fn + F7 . If an external monitor is connected, turn it on.
The screen saver is activated. Press any key or touch the TouchPad .
No image appears on the external
monitor I have plugged in and powered
on.
You haven’t installed the video driver and configured it appropriately from the
Control Panel . See Appendix C for instructions on installing and configuring
the video driver.
You forget the boot password . If you forget the password, you may have to discharge the battery of the CMOS.
Contact your service representative for help.
Problem Possible Cause - Solution

Password Warning
If you choose to set a boot password, NEVER forget your password. The consequences of this could be serious. If you cannot
remember your boot password you must contact your vendor and you may lose all of the information on your hard disk.