13
EN
7 - C
O M M I S S I O N I N G YO U R W I N E CA B I N E T
V - Changing the remote control batteries
The lifespan of the LR03/AAA batteries in the remote control is estimated to be between 8 to 12
months depending on usage.
A warning light
on the remote control’s display will tell you that the batteries (2x LR03/AAA)
need replacing as quickly as possible.
1 - Open the battery compartment cover on the back of the remote control.
2 - Insert the batteries ensuring correct polarity.
3 - Close the flap and your remote control is once more ready to use.
Your wine cabinet will continue to operate normally even when the remote control’s batteries are
discharged. When the batteries have been replaced, the remote control will automatically reset itself
to the previous configuration.
In the event of a power failure, your wine cabinet will switch off. If this happens, keep the wine
cabinet’s door closed and avoid opening at all costs. The system will re-boot once the power supply is re-established.
VI - Adding a second remote control for the same wine cabinet
Set up the second remote control as follows
If you wish, you can have an additional remote control for your wine cabinet, for that disconnect the cabinet and then reconnect it a few seconds.
The cabinet will also recognise your additional remote control.
If this is not the case, press simultaneously on the
and
keys until “deg” is displayed.
Choose unit °F or °C
and
a keys.Then press on
.
In the event that you have several Origine cabinets, select the allocated to your re q u i re m e n t s , number of the wine cabinet, then press on
to confirm.
Select the number of the display AFF = 2 (Second display). Press and hold down the
key.
The Prg + symbol display
appears whilst the data is being transferred to the wine cabinet.
Caution: A second display cannot be re- allocated in the same way as the original on the same wine cabinet.
To identify your display nu m b e r, p ress
or
. “AFF” will appear with the display number for a few seconds befo re displaying the temperature again.
VII - Setting the wine cabinet Number
If you have several models of this wine cabinet, each remote control is allocated to a specific wine cabinet.
To make it easier to identify the remote controls, allocate each wine cabinet a number and enter it into the remote control program menu as follows:
If this is not the case, press simultaneously on the
and
keys until “deg” is displayed.
Choose unit °F or °C
and
a keys.Then press on
.
In the event that you have several Origine cabinets, select the allocated to your re q u i re m e n t s , number of the wine cabinet, then press on
to confirm.
Select the number of the display AFF = 2 (Second display). Press and hold down the
key.
The Prg + symbol display appears
whilst the data is being transferred to the wine cabinet.
If you have only one Origine cabinet, you can allocate the wine cabinet number as 0, in which case no number will appear on the screen
in temperature display mode.
