EuroCaravaning VANTourer 2021, Руководство пользователя

Страница: 124 / 154

20
124
TrOuBLEShOOTiNg ANd FAuLT rECTiFiCATiON
109-0006-08EN - 21/09
8. Loosen both nuts (Fig. 65, item 2) of the rear light with
the tool in the onboard toolkit (Fig. 65, item 1) and
remove them by hand.
9. Carefully remove the rear light from the vehicle.
10. Unscrew the screws of the inner lamp socket and pull
out lamp socket.
NOTE!
Please observe the instructions in the operat-
ing manual provided by the manufacturer of
the base vehicle.
11. Open the bayonet lock of the illuminant and replace
the illuminant.
To re-fit, proceed in the reverse sequence.
Tighten the screws by hand.
NOTE!
Depending on the base vehicle, equipment and
layout, an inspection opening can be found in
the gas locker. When refitting. Ensure that the
seal is not damaged and that the gas locker is
closed tightly again.
10900326
1
2
Fig. 65 Rear light nut with tool from the onboard toolkit
20.2 Changing a wheel
DANGER!
)
You should only change a wheel on firm, level ground and well away from moving traffic!
)
Other road users must be made aware of your motorhome according to the national regulations which
apply in the country you are visiting, e.g. by using the hazard warning triangle!
)
Never lie under the motorhome when it is jacked up!
)
The wheel jack is only provided for wheel changing. It must never be used for carrying out work under
the motorhome!
CAUTION!
Additional support legs fitted (accessories) must not be used to jack up the motorhome!
The spare wheel is located underneath the motorhome behind the rear axle.