ISSUE 1/Original version/OCT 2013
13
TURNING MACHINE ON AND OFF
THE CONTROL PANEL
The control panel on your magnetic drilling machine is designed for maximum operating
facility and safety.
1 - The Motor Switch:
This switch is used to switch the motor
unit ON and OFF;
2 - The Magnet LED Indicator:
This LED indicator shows the generated
magnetic Force;
3 - The Magnet Switch:
This switch is used to switch the magnet On
and Off.
In order to operate properly, the machine has to be turned on following the procedure as described
below.
ACTIVATING THE MAGNET
Connect the machine to the mains/work piece. To activate the magnet, press the red button
(Fig. 2 – 3). The switch will be lit (red). The LED indicator (Fig. 2 - 2) will be lit GREEN if generated
magnetic force is sufficient. When LED indicator turns RED there is not enough magnetic force and it
is not safe to work. To deactivate the magnet, press the same button (Fig. 2 -3) again.
TURNING THE MOTOR ON AND OFF
The motor unit can only be switched ON when the magnet is activated. To turn the motor ON, by
pressing the green button with marking “I”(Fig. 2 - 1). To switch the motor OFF, press the red button
with marking “O”(Fig. 2 - 1).
Fig. 2
