Euroalpi Pasubio, Руководство по эксплуатации и обслуживанию

Страница: 19 / 45

19
10.5 Changing the heating power set
During the normal operation of the stove (Work), you can change the heat power output by using the
buttons P5 (Decrease) and P6 (Increase). The power level set is shown on the display. (
Figure 7
) To exit
from the menu wait 5 seconds without performing any operation on the keyboard, or press P3.
Figure 7
10.6 Changing the room temperature
To change the room temperature it is enough to act on the button P1. The display shows the set room
temperature (SET temperature). Thus acting on the buttons P1 (increase) and P2 (decrease) it is possible to
change the value. After about 5 seconds the value is saved and the display returns to the normal mode, or
press P3 to exit. (
Figure 8
)
.
Figure 8
10.7 The room temperature reaches the set temperature
(SET temperature)
When the room temperature has reached the set value, the heating power of the stove is automatically
decreased to the minimum value. Under these conditions, the display shows the message
"
MODULAT-". (
Figure 9
). If the room temperature decreases below the set one (Set temperature) the
stove goes back to "Work" mode and to the power previously set (Set power).
Figure 9
03
set
power
30.0°
C
Set room
temp
14:15
22.5°c P-2
work
Modulat-