EURO EG60BS, Инструкция по эксплуатации и техническому обслуживанию, Страница: 5 / 12

5
number label.
REPLACING INJECTORS (fi g. 8)
The hob is preset with natural gas. The ap-
pliance is preset with the injectors necessary
for adaptation to bottled gas ( propane).
If the hob has to be changed from natural
gas, proceed as follows:
- Remove the grid, the burner caps (A), and
the burners (B);
- Unscrew and remove the injector in the
bottom of each injector holder (C);
- replace the injector in accordance with the
table in page 3, tighten and screw right
down;
- remove the Natural Gas regulator and
replace with the test point assembly.
- check that the system is gas-tight ;
- replace the burners, the burner caps and
the grid.
With triple fl ame burners (fi g. 8b):
- carry out the operations already described
and also
- unscrew the two screws which secure the
guard plate (D) and replace the side injector
as indicated in the table on page 18, screw
in and tighten fully.
IMPORTANT:
- Never over-tighten the injectors;
- after replacing, check that all the injectors
are airtight.
SETTING HOB BURNER MINIMUM LE-
VELS
If the hob is to work on bottled gas (butane/
propane), the tap by-pass must be screwed
right down. The hob may be equipped with
type A taps, with by-pass inside (accessed by
inserting a small screwdriver into the rod) or
type B taps, with by-pass on the outside on
the right (accessed directly). See fi gure 9.
If the cooker is to work on natural gas, pro-
ceed as follows for both types of tap:
- Ignite the burner at maximum fl ame;
- pull off the knob, without using a lever
against the control panel, which might be
damaged;
- access the by-pass with a small screwdriver
and back off by about 3 turns (turning the
screwdriver anti-clockwise);
- turn the tap rod anti-clockwise again until
it stops: the burner will be at maximum
fl ame;
- screw the by-pass slowly back in, without
pushing the screw-driver, until the fl ame
has apparently shrunk to 1/4 of the ma-
ximum size, checking that it is suffi ciently
stable even in quite strong draughts.
CONNECTING TO THE ELECTRICAL
MAINS
Before making the connection, check that:
- the mains voltage is as indicated on the
nameplate;
- the earth connection is in good working
order.
If the socket is not easily accessible, the in-
stallation engineer must provide a switch with
a contact breaking gap of 3 mm or more.
If the appliance power lead is not fi tted with
a plug, use an approved standard type, re-
membering that:
- the green-yellow wire must be used for the
earth connection;
- the blue wire is the neutral;
- the brown wire is live;
- the lead must never touch hot surfaces over
about 75 degrees C;
- in case of replacement, the power lead
must be of type H05RR-F or H05V2V2-F
of adequate gauge (see fi g.2) for gas and
all-electric appliances, and type FR 3 R3 of
adequate gauge (see fi g.2) for gas-electric
appliances;
- the power supply lead must only be repla-
ced by a qualifi ed person.
IMPORTANT :
the manufacturer declines all liability for
damage due to failure to comply with the
regulations and standards in force. Check
that the appliance is correctly connected to
the earth (see diagrams in fi g. 2 at the back
of the manual).
Installation
AU