5
(3). Installation – Fitting the Rangehood.
This Rangehood must be placed at a distance of 65cm minimum from the
cooking surface of a cooker/hotplate and 120cm minimum from the
cooking surface of a BBQ.
3.1
Models without Glass:
3.1
Fit the plastic flaps to the outlet vent of the canopy by deforming
the flaps slightly so that the ends fit into the holes (refer to Pic 3 for
location of the flaps).
3.2 Fit the supplied Hook to the wall using the 36mm long screws
supplied (refer to Pic 1). Fixing method to the wall must be capable of
supporting the weight of the Canopy.
3.3
Lift the Canopy onto the Hook and make sure both left and right
hand hooks are engaged (refer to Pic 1).
3.4
Fit the Flexible Duct (not supplied) to the plastic outlet (refer to Pic
2).
3.5
Exhaust the Flexible Duct to the outdoors and fit a one way valve
to prevent rain & dust entering into the Canopy.
3.6
Determine the height of the U-shaped section. Line up the holes in
the plate with those in the lower U-Shaped section and fix the plate to the
wall using the 36mm long screws supplied (refer to Pic 3 item 1).
3.7
Align the holes in the lower corner of the U-shaped section and fit
the 9mm screw supplied through each side (refer to Pic 3 item 3).
3.8
Pull up the inner U-shaped section to a suitable height and align it
with the upper plate (refer to pic 4).
3.9
Fix the upper plate to the wall using the 36mm long screws. Fix the
inner U-shaped section to the upper plate using two 9mm screws on either
side of the bracket (refer to pic 4).
3.10 Finally, drill two Ø3.5mm holes in line with the 2
nd
plate where the
upper and lower sections overlap. Use a 9mm long screw on each side to
fix them together.
