EURO E1200ISLSX, Инструкция по установке, использованию и обслуживанию

Страница: 6 / 12

* In its sucking version (Fig. 1), fumes are directly conveyed outside, through an evacuation
duct connected with the superior part of the wall or the ceiling. Both coal filter and air deflector
are not necessary in this case.
- USES GB
6
* Before installing the appliance, in order not to damage the appliance itself, the metal gre-
ase filter should be removed. Such filter can be removed by pushing the special filter handle
toward the back side of the cooker hood and turning it downwards so to unfasten it from its
slot (Fig. 2).
Attention: at least two people are needed to perform the installation.
Before fixing the hood, place the electric feeding properly into the ornamental pipe and place
a hole for air evacuation in case of a sucking version.
* Suction model
Place the upper plate (Fig. 3.1) on the ceiling. Drill 4 holes, 8 mm each, just next to the slots.
Insert the plastic dowels into the holes (Fig. 3A) and screw up the plate on the ceiling (Fig. 3B).
Then fasten the lower structure (Fig. 4.2) on the hood by making its holes and the metric-
thread screws welded on the fan support coincide (Fig. 4.1). Insert the washers and nuts pro-
vided (Fig. 4.2) and screw with an appropriate tool.
Connect the drainpipe to the power unit nozzle and fix securely with a hose clamp.
Insert the upper structure (Fig. 4.3) into the lowest one and adjust its height as required by
matching it with the cooking top’s minimum height. Tighten the two structures securely with
the screws provided (Fig. 4.3-B).
Insert the two extension tubes (Fig. 4.4 & Fig. 4.5) from above the two structures by making
them come down to the appropriate hood seat. Lift the hood together with the structure and
the extension tubes to make the four springs (Fig. 4.6-E) hook to the slots (Fig. 4.3-C). Then
tighten the two elements securely (Fig. 5.1 & Fig. 5.2) with the safety screws (Fig. 5.2-A) and
connect the hood tube to the drain hole.
Make the electrical connections.
Lift the upper tube (Fig. 4.5) up to the ceiling and insert the two self-tapping screws (Fig.
4.5-D).
Warning!
Before connecting the flexible exhausting pipe to the motor, make sure the stop valve, which
is on the air outlet of the motor, can swing.
Warning: Failure to install the screws or fixing device in accordance with these instructions
may result in electrical hazards.
- INSTALLATION GB
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety. Children should be supervised to ensure that they do not play with the applian-
ce.
Do not flambè under the range hood.
CAUTION: Accessible parts may become hot when used with cooking appliances.