Euro Shatal ST122 - M12800 - ROBIN GASOLINE, Инструкция по эксплуатации/Перечень запасных частей

Страница: 9 / 23

OPERATION- HONDA GX-160;GX-240
POWER TROWELS
ST92 ST122
ST92 ST122 -8- DECEMBER 2002
ENGLISH
Operating the trowel
NOTE
Always operate the trowel using the Dead Man Control H andle. Always ensure
that the black knob is in the outward position. Do not operate with this knob in the
inward position. This is to be used only when or during starting the engine.
Assembly of the float disc
1. Place the trowel on to the float disc.
2. Rotate the blades so that the blades move
underneath the 4 L shaped brackets.
3. Rotate the blade adjustment knob so that
the blades rise.
4. Ensure that there is sufficient pressure on
the blades and that the disc is tightly
attached to the trowel.
NOTE
The trowel is to be used only by experienced operators. They must have the
knowledge of when the concrete is ready to be troweled , the angle of the blades
and the operating speed.
These instructions should be used as general guidance only.
Floating concrete
Use the float disc or the blades set at a small angle for floating.
The concrete should be sufficiently set before the floating operation takes place.
This must be determined by the operator.
Floating is done at a low speed. To have the machine move to the right bear down
slightly on the handle. Lift gently on the handle to have machine move to the left.
Do not operate machine in one spot but keep it moving over the surface for either
floating or finishing of concrete. If machine is allowed to stand in one spot while
not operating , lift up on the handle to break loose the suction on the trowels and
move to a new spot before starting to operate the machine.
Finishing concrete
The finishing operation is carried out with the blades set at a large angle and at a
high speed.