OPERATING INSTRUCTIONS
5.
Connect the wire terminal connector from the unit to the wire terminal connector of
the new battery pack, and replace the battery pack into the unit. Replace the cover
and press until it snaps in place.
6. Follow instructions for initial battery charging. Please call customer service at
1 (800) 798-7398 if there are any problems removing batteries.
Do NOT
attempt to replace the batteries used in this product with any other type of
battery.
Important:
This appliance contains Ni-Cd batteries. The batteries must be
recycled or disposed of in accordance with local regulations. Please consult your
Yellow Pages or local recycling center for more information.
6
Fig. 5
4.
Carefully lift out the battery pack and disconnect the wire terminals by pulling apart
the wire terminal connectors. Remove the battery pack from the unit. (Fig. 5)
Wire Terminal Connector
How To Operate Your Cordless Sweeper
1.
Before using, please ensure that the cordless sweeper has been initially
charged for 20 hours.
Your cordless sweeper will only operate properly when the batteries are fully
charged. Your sweeper will operate for varying lengths of time on a full charge.
This will depend upon the type of surface being cleaned. (Longer operating time on
bare floors vs. carpets.)
2.
Push the On/Off switch to operate the unit. To turn off, press switch again. (Fig. 6)
7
OPERATING INSTRUCTIONS
"On/Off“ switch
Fig. 6
4.
To change the speed of the sweeper, press on the speed control button. As you
press on it, the speed indicator light will change. If one light lights up, you have the
low speed for hard floors; two lights, medium speed for carpeting; three lights, high
speed for turbo deep cleaning. (Fig. 8)
Fig. 7
3.
To release the handle to a comfortable position, gently apply pressure to the top of
the sweeper head with your foot while pulling back on the handle. (Fig. 7)
Anti-Jam Brush Roll Feature
This feature protects your unit’s motor from damage due to overheating, that may be
caused by the rotating brush getting jammed or tangled in something. If the rotating
brush becomes overloaded it will stop turning and both speed indicator lights will
remain flash at the same time. To reset the unit:
1.
Press On/Off switch.
2.
Remove the transparent brush cover from the sweeper power head to remove any
build up of lint, hair or fiber on the rotating brushes.
3.
Wait for 10 seconds to allow the unit to cool down.
4.
Press On/Off switch again, the unit should restart.
Hard floors
Carpeting
Turbo Deep
Cleaning
Fig. 8
Содержание V1917H
Страница 2: ......
