To attach the window squeegee to the steam diffuser, place the two hinges at the
back of the window squeegee (see illustration) into the two open tabs that are at the
back of the steam diffuser. Swing the window squeegee up against the bottom of the
steam diffuser until the locking tab engages.
Concentrator Nozzle / Steam
Diffuser
To attach the concentrator nozzle or
the steam diffuser to the nozzle, align
the end of the concentrator nozzle /
steam diffuser that has the two pins
with the notches in the nozzle of the
unit. Push the attachment into the
nozzle until it stops against the
appliance. Turn in a clockwise
direction until it locks in place. (See
illustration.) The attachment is now
locked into position.
How To Assemble & Use
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
Attachments
CAUTION:
Always ensure the unit is “
UNPLUGGED
” from the wall
receptacle prior to filling or re-filling the water tank. Failure to follow these
steps will cause the water tank to overfill.
Step 1: Before filling the steam cleaner, make sure that the unit is
NOT
plugged in.
Step 2: Turn Safety Cap counter clockwise until removed.
Step 3: Place funnel in the tank and add water.
Do not overfill.
Replace Safety
Cap by turning clockwise - press down firmly to tighten.
Heating time is approximately 5-6 minutes. Filling the boiler with hot water
will shorten heat up time.
Step 4: Plug the unit into a standard 120 volt wall receptacle. The power light will
light up.
Step 5: Allow approximately 5-6 minutes for water vapor to reach its working
temperature and pressure.
Step 6: At the start, some water will come out from the nozzle. This is normal.
WARNING:
Disconnect steam cleaner from wall outlet before refilling.
It is time to refill your steam cleaner when there is no more steam coming out
of the nozzle. Because the water tank is pressurized, use caution when
opening to refill. Always let unit cool for 5 minutes before opening the safety
cap. Depress the trigger button while you unscrew the safety cap
counterclockwise.
Window Squeegee
CAUTION:
When cleaning outside windows, always avoid any sudden
changes in temperature to prevent breakage or cracks.
CAUTION:
When refilling the appliance while it is still hot, the first drops
of water might bubble up.
Use caution when opening the Safety Cap.
Refilling With Water
Step 1: Disconnect electrical power cord from wall outlet.
Step 2: Press trigger button until all pressure has been
released.
Step 3: Wait for approximately 5 minutes before carefully
unscrewing the safety cap.
Step 4: Turn slowly a half turn and wait for the hissing
noise created by residual steam to stop.
Step 5: Unscrew the safety cap completely and allow
to cool.
Step 6: Slowly pour water using the measuring cup and
the funnel into the boiler.
DO NOT OVERFILL
.
Always leave approximately an inch between
the top of the unit and the water level.
Step 7: Screw safety cap back on the appliance and plug appliance back into wall
outlet. Steam will start to be produced as before.
To remove the window squeegee from the
steam diffuser, just push your thumb against
the locking tab on the window squeegee.
WARNING:
T
his appliance is under pressure. After every use, press
trigger button until all pressure has been released before removing safety cap.
6
5
