IMPORTANT SAFETY INSTRUCTIONS
TROUBLE SHOOTING GUIDE
When using your
SHARK TURBO STICK VAC
basic safety precautions should
always be observed, including the following:
ORDERING REPLACEMENT DUST CUP FILTERS
PROBLEM
POSSIBLE REASON
POSSIBLE SOLUTION
VACUUM WILL
NOT OPERATE
1.
Power cord not firmly plugged into
outlet.
2.
No power in wall outlet.
3. Needs
servicing.
4.
Thermostat has tripped.
1.
Plug unit in firmly.
2.
Check fuse or breaker. Replace
fuse/reset breaker.
3. Call
1-800-798-7398.
4.
Turn the unit off and unplug from
outlet. Allow unit to cool down,
then restart.
VACUUM WILL
NOT PICK-UP OR
SUCTION POWER
IS WEAK
1.
Dust cup is full.
2. Unit
clogged.
3. HEPA-Type
Filter
needs
cleaning
or replacing.
4.
Debris screen needs cleaning.
1.
Empty and clean dust cup.
2.
Turn unit off and unplug from
wall outlet. Remove Dust Cup
Filter and check for object(s) in
air duct and remove.
3.
Clean or replace HEPA-Type
Filter.
4. Clean
debris
screen.
DUST ESCAPING
FROM VACUUM
1.
Dust cup is full.
2.
Dust Cup is not installed correctly.
1.
Empty and clean dust cup.
2.
Review Dust Cup instructions.
VACUUM, HOSE
OR BRUSHES
WILL NOT PICK-UP
1. Hose
clogged.
2.
Dust cup is full.
1.
Remove hose and/or brushes.
Remove obstruction from hose
and /or brush.
2.
Empty and clean dust cup.
To reduce the risk of fire, electric shock, or
injury:
•
Do not
leave the
SHARK TURBO STICK
VAC
plugged in when unattended. Unplug the
electrical cord when not in use and before
servicing.
•
Do not
allow to be used as a toy. Close
attention is necessary when used by or near
children, pets or plants.
•
Use only as described in this manual. Use
only manufacturer’s recommended
accessories.
•
Do not
pull cord, use cord as a handle, close
a door on cord, or pull cord around sharp
edges or corners. Keep cord away from
heated surfaces.
•
Use
only
extension cords UL-rated or cUL at
15 amperes. extension cords rated for less
amperage may overheat. Care should be
taken to arrange the cord so that the cord
cannot be pulled or tripped over.
•
Turn off all controls as applicable before
unplugging from electrical outlet.
•
Do not
unplug by pulling on cord. To unplug,
grasp the plug, not the cord.
•
Do not
handle plug or hand vacuum with wet
hands or operate without shoes.
•
Do not
put any objects into openings. Do not
use with any opening blocked. Keep free of
dust, lint, hair and anything else that may
reduce air flow.
•
Store your appliance indoors in a cool, dry
area.
•
Keep your work area well lit.
•
Do not
immerse the hand vacuum into water
or other liquids.
•
Keep end of hose, wands and other openings
away from your face and body.
•
Use only on dry surfaces.
•
Using improper voltage may result in damage
to the motor and possible injury to the user.
Correct voltage is listed on rating label.
1.
Read all instructions before using your
SHARK TURBO STICK VAC
.
2.
Use the system only for its intended use.
3.
To protect against a risk of electric shock,
do not immerse any part of the system in
water or other liquids.
4.
Never yank cord to disconnect from
outlet; instead, grasp plug and pull to
disconnect.
5.
Do not
allow cord to touch hot surfaces.
6.
Do not
run appliance over cord.
7.
Do not
operate the system with a damaged
cord or plug, or if the appliance or any other
part of the system has been dropped or
damaged. To avoid the risk of electric
shock, do not disassemble or attempt to
repair the
SHARK TURBO STICK VAC
.
Return the system to
EURO-PRO
Operating LLC (see warranty) for
examination and repair. Incorrect re-
assembly or repair can cause a risk of
electrical shock or injury to persons when
the
SHARK TURBO STICK VAC
is used.
8.
Close supervision is necessary for any
appliance being used by or near children.
Do not leave the system unattended while
connected.
9.
Keep hair, loose clothing, fingers and all
parts of body away from opening and
moving parts.
10.
Do not
use to pick up flammable or
combustible liquids such as gasoline or use
in areas where they may be present.
11.
Do not
pick up anything that is burning or
smoking such as cigarettes, matches or hot
ashes.
12. Use extra care when cleaning on stairs.
13.
Do not
use the hand vacuum without the
HEPA-TYPE dust cup filter in place.
14. This appliance is intended only for
household use. Follow all user instructions
in this manual.
TO ORDER REPLACEMENT HEPA-TYPE FILTERS
Item # XSH600
for Model EP600
Call:
1-866-98SHARK (1-866-987-4275)
Monday to Friday 8:30 A.M. - 5:00 P.M. Eastern Standard Time
FOR TECHNICAL SUPPORT
for Model EP600
SAVE THESE INSTRUCTIONS
or
visit our website: www.sharkvac.com
Call:
1-800-798-7398
Monday to Friday 8:30 A.M. - 5:00 P.M. Eastern Standard Time
For Household Use Only
Please Note:
The HEPA-TYPE Filter is washable. It should, however, be replaced every three (3)
months to ensure peak performance of your vacuum.
Both the Pre-Motor and Post Motor Filters are washable. They should however be
replaced every three (3) months to ensure peak performance of your vacuum.
Important:
Make sure that
ALL
filters have been completely air dried for 24 hours before re-
installing back in the vacuum.
WARNING:
To reduce the risk of electric shock, this appliance has
a polarized plug (one blade is wider than the other). This plug will fit
in a polarized outlet only one way. If the plug does not fit fully in the
outlet, reverse the plug. If it still does not fit, contact a qualified electrician
to install the proper outlet. Do not modify the plug in any way.
8
Rev. 04/01
1
