Euro Appliances MILAN EMEO45SX, Инструкция пользователя

Страница: 5 / 20

All work on the appliances must be carried out by qualified personnel.
For maintenance, moving, installation and cleaning of the appliance use suitable
prevention and protection equipment (gloves, etc.).
Lifting and moving of appliances weighing more than 25 kg must be carried
out using proper equipment, or by two persons, in order to avoid risks or injuries.
The oven is equipped with a cooling fan that comes on when the cooking cycle is
selected. It creates a slight air flow that exits from the slot under the control panel. It
shuts down 10-30 minutes after the oven is switched off (depending on
oven temperature).
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.Children should be
supervised to ensure that they do not play with the appliance.
W ARNING: Accessible parts may become hot during use. Young children
should be kept away.
Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door
glass since they can scratch the surface, which may result in shattering of the
glass
The instructions for ovens that have shelves shall include details indicating the
correct installation of shelves (IEC 60335-2-6)
Unless the instructions state to the contrary, the instructions for cooking ranges
and ovens shall state that the appliance must not be installed behind a decorative
door in order to avoid overheating. (IEC 60335-2-6)
Allow disconnection of the appliance after installation, by accessible plug or a
switch in the fixed wiring, unless.
Cleaning and user maintenance shall not be made by children.
INSTRUCTIONS FOR INSTALLATION OF THE UNIT
All tasks involved in installing the appliance must be carried out by
skilled personnel. Any work is to be performed with the appliance unplugged.
Electrical connection:
make sure that the voltage corresponds to that indicated on the tag on the side. The
oven must be connected using a cable with a minimum cross-section of 1,5 mm
on the rear, and with an omni-polar switch compliant with current standards with
a distance of aperture between contacts of at least 3 mm.
Caution:
if you need to replace the power cord, make sure you comply with the following
colour-code when connecting the single wires: