INSTALLATION WITH EXISTING FRAME
INSTALLATION WITHOUT EXISTING FRAME
©2019. Euri Lighting | A Division of IRTRONIX Inc. All Rights Reserved
THIS PRODUCT MAY NOT BE COMPATIBLE WITH ALL DIMMERS, FOR MORE INFORMATION ABOUT DIMMER COMPATIBILITY PLEASE VISIT: WWW.EURILIGHTING.COM
INSTALLATION GUIDE
MODEL #:
DLC6C-18W103swej / DLC8C-22W103swej
For customer service please call us at 1-310-787-1100
Office Hours: 8:00 a.m. – 5:00 p.m. PST Monday-Friday
Questions?
Downlight Series | Fixed Class
6”-8”LED Downlight
PLEASE REVIEW THE INSTRUCTIONS AND WARNINGS LISTED BELOW PRIOR TO PROPER INSTALLATION
6
”
-8
"
LED
Commercial Downlight
1. Shut power OFF to the fixture.
2. Remove the old housing for a lamp. (Fig.1)
5. Adjust the fixture power to the desired
lumen output by sliding the black selector
switch. Adjust the color temperature to the
desired one, by sliding the red selector switch.
(Fig.4)
1. Make sure the POWER IS TURNED
OFF at the source to the location in
which you are installing the product.
2. Use a template inside the box to
cut a hole in the ceiling. (Fig.7)
3. Attach the carabiner safety clip to the
existing fixture. (Fig.2)
6. Install the downlight by lifting both
retention tabs upward. (Fig.5)
3. Select the desired lumen output and
CCT. (Fig. 8)
5. Push until the trim sits flush against
the ceiling. (Fig.10)
4. Insert lamp conduit
into a preinstalled J-box
(not provided) and wire to
the power source (black
to hot, white to neutral,
green to the ground). For
0-10V dimming circuits,
connect grey to grey and
purple to purple. Close the
J-box securely. Install the
downlight by lifting both
retention tabs upward.
(Fig. 9)
7. Push until the trim sits flush against
the ceiling. (Fig.6)
8. Restore power at the source and the
installation is complete.
4. Remove junction box faceplate.
Disconnect all wires to the ballast
and remove the ballast from J-Box.
Remove appropriate round knock out
and attach the fixture conduit whip into
the knockout. Connect incoming power
(White to White, Black to Black, Green
to Green/Ground). For 0-10V dimming
circuits, connect Grey to Grey and Purple
to Purple. Reattach J-Box faceplate.
(Fig.3)
Fig.1
Fig.4
Fig.7
Fig.8
Fig.9
Fig.2
Fig.5
Fig.6
Fig.3
Note:
These instructions do not
cover all details or variations in
equipment nor do they provide
for every possible situation
during installation, operation or
maintenance.
