www.eureka.com
9
Cleaning in handheld mode
Let the unit cool down for a few minutes
before removing or installing tools or hose
as the end of the machine will be hot.
!
C A U T I O N
Do not direct steam at people animals or at
electrical outlets.
!
C A U T I O N
Note:
Special accessory attachments should
not be connected directly to the tip of the
handheld unit or hose. They should be
attached to the straight nozzle for use.
The Eureka steam mop handheld mode is designed
to clean surfaces that can withstand high heat
and moisture. Do not use on unsealed wood
surfaces (such as antiques), unglazed ceramic tile,
painted surfaces or surfaces that have been treated
with wax, oils, varnishes or shellac. It is always
recommended to test an isolated, inconspicuous
area of the surface to be cleaned and refer to the
care instructions from the surface manufacturer.
Please refer to the “Light indicators for
cleaning mode (both floor and handheld)”
section on page 7.
Note:
When using in handheld mode, you
must hold down the spray trigger to release
steam otherwise steam will not come out.
(
Fig. 1
)
Hose assembly with straight nozzle
Align the open end of the hose assembly with the
opening at the bottom of the main body until you
hear a Click to make sure it is installed properly.
If you don’t hear a click please rotate the hose
connector until you hear it click into place.
(Fig. 2)
Insert tip of the end of the hose with the opening
on the straight nozzle attachment and push down
hose. Then rotate the straight nozzle until the tab
is locked in place.
(Fig. 3)
Install the specialty cleaning accessories by
aligning the opening of the accessory with the tip
of the straight nozzle and push in then rotate the
accessory until the tab is locked in place.
(Fig. 4)
2
3
4
Click!
Click!
1
MODE Button
Spray Trigger
