Step 3
1. Use a square to ensure the fascia assembly is
perfectly vertical.
2. Using a 3mm dia drill bit (supplied), drill holes (C)
and (D) through the fascia assembly and into the side
of the heater. Insert screws (Part 5) and tighten.
3. Do this on the other side of the heater as well.
Step 6
1. Attach the fascia assembly removed in Step 4 with
screws tightened from the outside of the heater, on
both sides of the fascia assembly.
(C)
(D)
Square
Step 5
Position heater into masonry opening. Ensure it is centrally
located and the fascia assembly is hard up against wall.
Step 4
1. Attach the other fascia assembly as per steps 2 and 3.
2. Position fascia retaining Strip (Part 6) by placing it along the
edge of the Fascia Assembly (See detail). Ensure strip is flush
with bottom of heater.
3. Using a 3mm dia drill bit, drill 4 holes through the fascia
retaining strip and attach to the side of the heater.
4. Using a 3mm dia drill bit, drill through the other 4 holes in
the retaining strip into the fascia assembly.
5. Remove fascia retaining strip from heater and fascia
assembly
6. Remove the fascia assembly, and then re-drill the holes in the
fascia assembly to 5mm dia using drill bit supplied.
7. Repeat for the other side of heater.
8. Screw fascia retaining strip back into position on both sides
of heater
Sheet 3 of 4 GPN 215238
F:\Docs\Manuals\Heaters\HM215238\Duet In Wall Inst
(through Windows NT Explorer)
Drill holes
Drill holes
Drill
holes
Fascia Assembly
Fascia Retaining Strip
Ensure flush at bottom
Insert screws
(4 each side)
Step 7
1. If required use spray can (Part 4) to touch up if required. Follow
directions on spray can.
