Eumetsat TBS-6903, Руководство по установке Windows

Страница: 8 / 32

EUM/OPS/MAN/15/794850
v2 e-signed, 15 March 2016
TBS-6903/6908 DVB-S2 Receiver EUMETCast Windows Setup Guide
Page 8 of 32
The connectors used in the TBS-6903/TBS6908 device configuration are described in the
following table:
Number Connector
1 PCIe 1.x Connector
2 RF In
3 Power Cable Connector

Plug-in the connector 1 to a free PCIe slot of your PC ;

Connect the antenna cable to one of the four connectors 2;

Connect the Power Cable Connector 3 to the power using the TBS-6908 power cable
(Figure 3)

Install the windows drivers (see paragraph 3.2) ;

Install and Configure IP Tool ( s ee paragraph 4) ;

Instead of IP tool you can use BDADataEx (see paragraph 5)

Configure Tellicast (see paragraph 4.1) ;
Notes:
i. On TBS-6903/6908 to get adapter 0 use the lower plug.
ii. The external power plug is optional. It needs to be used in very rare cases when there is
no enough power from PCIe slot. (The LNB Input on TBS cards can provide 450mA. If
the user has only LNB connected on the coaxial cable, then the external power is not
needed as one LNB is on average 100mA. If there are things like motor, DiSEqC devices
on the same coaxial cable, then the power consumption can go up and external power be
needed).
3.2 Windows Drivers Installation
a) You can find the latest windows driver at tbsdtv web site :
http://www.tbsdtv.com/download/
The version used for EUMETSAT testing the TBS-6903 card was v.1.0.0.3,, for the TBS-
6908 card was v.1.0.0.6.
b) Run the driver installer (TBS_69xx_driver_setup.exe)
c)
In case you get a security message, select “Yes”